Service Program Mode
D017/D018/D019/D020 5-12 SM
5.1.4 SERVICE PROGRAM MODE TABLES
Service Table Key
Notation What it means
[range / default /
step]
Example: [-9 to +9 / +3.0 / 0.1 mm step]. The setting can be
adjusted in the range ±9, the setting is reset to +3.0 after an
NVRAM reset, and the value can be changed in 0.1 mm steps
with each key press.
italics Comments added for reference.
*
Value stored in NVRAM. After a RAM reset, this default value
(factory setting) is restored.
1111
An SP number set in bold denotes a “Special Service Program”
mode setting that appears only after entering the SP mode by
pressing and Copy SP together. (See ‘Service Program Mode
Operation’.)
DFU
“Design or Factory Use”. Do not change this value.
Japan only
The feature or item is for Japan only. Do not change this value.
(S) Sideways feed direction
(L) Lengthwise feed direction
To Next Page
Loading...
Need help?
General