Energy Saver Modes
SM 6-77 D017/D018/D019/D020
Detailed
Descriptions
 The panel off timer runs out
 The Clear Mode/Energy Saver Key is held down for one second
Note that the default setting of the panel off timer is 60 s, which is the same as the auto off
timer. In this condition, if the machine is not touched for 60 s, it will go straight to auto off
mode. If the user wants an energy saver mode and an auto off mode, the panel off timer
must be set to a shorter value than the auto off timer.
What happens in energy saver mode
When the machine enters energy saver mode, the fusing lamp drops to a certain
temperature, and the operation panel indicators are turned off except for the Energy Saver
LED and the Power LED.
If the CPU receives an image print out command from an application (e. g. to print
incoming fax data or to print data from a PC), the fusing temperature rises to print the data.
Return to stand-by mode
If one of the following is done, the machine returns to stand-by mode:
 The Clear Mode/Energy Saver Mode key is pressed
 Any key on the operation panel or touch panel screen is pressed
 An original is placed in the ADF
 The ADF is lifted
 A sheet of paper is placed in the by-pass feed table
The recovery time from energy saver mode is about 3 s.
Mode
Operation
Switch
Energy
Saver LED
Fusing Temp. +24V System +5V
Energy
Saver
On On 150 °C On On
6.14.3 AUTO OFF MODE
There are two Auto Off modes: Off Stand-by mode and Off mode. The difference between
Off Stand-by mode and Off mode is the machine’s condition when it enters Auto Off mode.
 The machine will not enter the Auto Off mode for at least 90 seconds. after the
machine is turned on when applications other than Copy (printer/scanner, printer,
etc.) are installed.
To Next Page
Loading...
Need help?
General