Roche Diagnostics
Operator’s Manual · Version 3.1 B-7
Cedex Bio System 5 Daily operation
Introduction
Overview
The following table gives an overview of the tasks you might need to perform during
daily operation. Roche recommend using the sequence of steps in the way given
below; but you may perform the tasks differently. For details on the individual steps,
see the relevant sections in this chapter.
Task Steps Navigation
With wizard As individual steps
1
Starting the system 1. Switch on the system.
2
Logging on the system Overview > Logon
3
Preparing the system Start the Prepare wizard. Overview > Prepare
1. Check the external fluid containers. Overview > >
2. Perform the maintenance actions
that are due.
Utilities > Maintenance
3. Load the reagent disk. Overview >
4. Check the reagents. Overview >
5. Check the cuvettes. Overview >
6. Perform mixing Overview > > test >
7. Perform calibrations that are due. Workplace > Calibrations > >
4
Defining orders Start the Orders wizard. Overview > Order (or Overview > STAT)
1. Identify the sample. n/a
2. Select the tests. n/a
3. Place the sample. n/a
4. Start the run.
5
Monitoring the progress n/a Overview
6
Validating results 1. View results. n/a Workplace > Result Review
2. Handle flagged results. n/a Workplace > Result Review >
... > Repeat
... > Rerun
3. Accept results. n/a Workplace > Result Review > >
Accept
Table B-1 Overview of the daily operation tasks
To Next Page
Loading...
Need help?
General
