Xerox WorkCentre Series
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
10
Xerox WorkCentre Series
Your device is not simply a conventional copier, it is a digital device capable of copying, faxing, printing
and scanning, dependent on your model and configuration.
There are two configurations available:
• WorkCentre Copier/Printer - a multi-functional digital device capable of copying, printing, faxing
(optional), e-mailing and network scanning (optional).
• WorkCentre Copier/Printer/Scanner - an advanced multi-functional device offering a high
specification of features and functions. This model is capable of copying, printing, scanning, e-
mailing and faxing (optional).
Each model has seven configurations available which provide either 35, 40, 45, 55, 65, 75, or 90
copies/prints a minute. All configurations are fully upgradeable so as to meet any future requirements
you may have.
The following are supplied as standard:
• Document Feeder
• Paper Trays 1 and 2 - fully adjustable and can be used for media sizes 5.5x8.5” to 11x17” (A5
to A3).
• Paper Trays 3 and 4 - are high capacity paper trays used for media size 8.5x11” (A4).
• Bypass Tray - used for non-standard printing media.
The following are optional hardware, which are available for your device:
• Tray 5 - a high capacity paper tray used for media size 8.5x11” (A4). Optional kits are
available to accommodate 11x17” or 8.5x11” (A3 or A4) short edge feed media.
• Tray 6 (Inserter) - a paper tray for use with the High Volume Finisher. It is used to insert pre-
printed sheets into copy sets.
• High Volume Finisher (HVF) - a finisher which can collate, offset, stack and staple your
output. Booklet Maker, Trifold, Hole Punch and Post Process Inserter (PPI) kits can be installed
with this finisher.
• Booklet Maker and Trifolder - these are devices which can be installed with HVF to staple
and fold booklets or leaflets.
• Convenience Stapler - this provides manual stapling of up to 50 sheets. The Convenience
Shelf must also be fitted.
• Offset Catch Tray - this delivers output collated or uncollated, each set or stack will be offset
from the previous to enable easy separation.
• Basic Office Finisher - this device stacks, collates, staples and offsets your output.
• Office Finisher - this device stacks, collates, staples and offsets your output. Hole punch kits
are also available for this finisher.
To Next Page
Loading...
Need help?
General
