Windows 2000/2003/XP/Vista Environment
WorkCentreâ„¢ 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
70
Windows 2000/2003/XP/Vista Environment
Information Checklist
Before starting the procedure, ensure the following items are available or tasks have been performed:
For Static IP Address
Note: To configure this feature or these settings access the Tools pathway as a System
Administrator. For details, refer to Access Tools Pathway as a System Administrator on page 18.
1. From the Tools pathway, touch [Network Settings].
2. Touch [Network Setup].
3. Touch [TCP IP].
4. Touch [TCP/IP Settings].
5. Touch [TCP/IP Enablement], the TCP/IP Enablement screen displays.
a. Touch [Enable] for IPv4 and IPv6.
Note: Any changes to the IPv6 feature will result in a reboot of the Network Controller.
b. Touch [Save].
6. Touch [Automatic Addressing].
a. Touch [Disabled] to disable Automatic Addressing.
b. Touch [Save].
7. Touch [IP Address/Host Name], the IP Address/Host Name screen displays.
a. For IPv4 Address, touch each octet and enter the IP address using the numerical keypad.
b. For Host Name, touch the detail bar.
c. Enter Host Name using the on-screen keyboard. To access more characters, touch [123] on
the user interface.
d. Touch [Save], then touch [Save] to return to the TCP/IP Settings screen.
For Static IP Address For Dynamic IP Address
• Existing operational network utilizing the TCP/IP
protocol.
• Ensure that the device is connected to the
network.
• Static IP Address for the device.
• Subnet Mask Address for the device.
• Gateway Address for the device.
• Host Name for the device.
• Ethernet Cable.
• Print and Fax Drivers CD (delivered with your
device).
• Existing operational network utilizing the TCP/IP
protocol.
•A DHCP, BOOTP or RARP Server should be
available on the network.
• Ensure that the device is connected to the
network.
• Ethernet Cable.
• Print and Fax Drivers CD (delivered with your
device).
To Next Page
Loading...
Need help?
General
