WorkCentreâ„¢ 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
57
4
Internet Services
This chapter explains how to enable and use the Internet Services feature of the device.
The Internet Services feature uses the embedded HTTP Server on the device. This allows you to
communicate with the device through a web browser and gives you access to the Internet or intranet.
Entering the IP Address of the device as the URL (Universal Resource Locator) in the browser provides
direct access to the device.
Internet Services not only allow you to change basic settings on the Control Panel, but also allows you
to change more specialized settings for the device.
Information Checklist
Before accessing Internet Services, please ensure the following items are available or have been
performed:
• The device must be physically connected to the network with TCP/IP enabled so that Internet
Services can be accessed from a web browser.
• An existing operational workstation with TCP/IP Internet or Intranet accessibility is required.
• HTTP (HyperText Transfer Protocol) should be enabled on the device. HTTP is enabled by default.
If you need to enable HTTP, see Enable HTTP on the device on page 57.
Enable HTTP on the device
HyperText Transfer Protocol (HTTP) must be enabled on the device in order to access the embedded
HTTP server.
Note: To configure this feature or these settings access the Tools pathway as a System
Administrator. For details, refer to Access Tools Pathway as a System Administrator on page 18.
1. From the Tools pathway, touch [Network Settings].
2. Touch [Network Setup].
3. Touch [TCP IP].
4. From the TCP/IP screen, touch [HTTP/IPP Enablement].
a. For Protocol touch [Enable].
b. Touch [Save], to return to the TCP/IP screen.
5. Touch [Close].
6. Press the <Log In/Out> button.
7. Touch [Logout] to exit the Tools pathway.
To Next Page
Loading...
Need help?
General
