Network Configuration
WorkCentreâ„¢ 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
92
Network Configuration
This section explains how to set up the device to operate in a Windows TCP/IP environment. The
following information is provided:
• Configure Static IP Address using the Device on page 92
• Configure Dynamic Addressing on page 94
• Configure IP Settings using Internet Services on page 96
• IPv4 on page 96
• IPv6 on page 97
• Configure SLP on page 100
• Configure FTP on page 101
• SNMP (Simple Network Management Protocol) on page 102
• SSDP (Simple Service Discovery Protocol) on page 107
• Microsoft Networking on page 108
• LPR/LPD on page 110
• Raw TCP/IP Printing on page 112
• SMTP (Simple Mail Transfer Protocol) on page 113
• LDAP on page 115
• Configure POP3 Setup on page 121
• Configure HTTP on page 122
• Proxy Server on page 123
• NTP on page 124
• WSD on page 125
• Apple Talk on page 126
• NetWare on page 127
• AS400 Raw TCP/IP Printing to Port 9100 (CRTDEVPRT) on page 130
• UNIX on page 133
Note: The device supports IP versions 4 and 6. IPv6 can be used instead of or in addition to IPv4.
IPv4 Settings can be configured directly at the device user interface, or remotely, via a web
browser using Internet Services. IPv6 can only be configured using Internet Services. To configure
TCP/IP Settings using Internet Services, see Configure IP Settings using Internet Services on
page 96.
Configure Static IP Address using the Device
Information Checklist
Before starting the procedure, ensure the following items are available or tasks have been performed:
• Existing operational network utilizing the TCP/IP protocol.
• Ensure that the device is connected to the network.
To Next Page
Loading...
Need help?
General
