Windows using Microsoft (R) Networking
WorkCentreâ„¢ 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
79
Windows using Microsoft
(R)
Networking
NetBIOS over IP
Information Checklist
Before starting the procedure, ensure the following items are available or tasks have been performed:
• An existing operational network utilizing the TCP/IP protocol.
• A Static IP Address for the machine.
• A Subnet Mask Address for the machine.
• A Gateway Address for the machine.
• A Host Name for the machine.
• Ensure device is connected to the network with an Ethernet Cable.
• The CentreWare Print and Fax Drivers CD (delivered with your machine).
At the Machine
Note: To configure this feature or these settings access the Tools pathway as a System
Administrator. For details, refer to Access Tools Pathway as a System Administrator on page 18.
1. From the Tools pathway, touch [Network Settings].
2. Touch [Network Setup].
3. Touch [TCP/IP].
4. Touch [TCP/IP Settings].
5. In the TCP/IP Settings screen:
a. Touch the [Automatic Addressing] button.
b. Touch [Disabled].
c. Touch [Save].
6. Touch [IP Address/Host Name], in the IP Address/Host Name screen:
a. For IPv4 Address, touch each octet and enter the IP address using the numerical keypad.
b. For Host Name, touch detail bar.
c. Enter Host Name using the on-screen keyboard. To access more characters, touch [123] on
the user interface.
d. Touch [Save], then touch [Save] to return to the TCP/IP Settings screen.
7. Touch [Subnet and Gateway], in the Subnet and Gateway screen:
a. For IP Gateway, touch each octet under the title and enter IP Gateway address using the
numerical keypad.
b. Repeat this process for the Subnet Mask. When you are finished, touch [Save] to accept the
changes and return to the TCP/IP Settings screen.
c. Touch [Close] to return to the TCP/IP screen.
To Next Page
Loading...
Need help?
General
