Internet Services
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
25
To Setup HTTP
The Internet Services HTTP screen allows the System Administrator to specify the Keep Alive Timeout,
Maximum Connections, Port Number and Secure HTTP (SSL) settings.
Note: To configure this feature or these settings access the Properties tab as a System
Administrator. For details, refer to Access Internet Services as System Administrator on page 24.
1. From the Properties tab, click on the [Connectivity] link.
2. Click on the [Protocols] link.
3. Select [HTTP] in the directory tree.
4. In the Configuration area:
a. For Connection, select [Enabled] to enable the protocol.
b. For Secure HTTP (SSL), select [Enabled] to set the HTTP Security Mode.
c. Change the Port Number if required. The default is 443.
d. The [Keep Alive Timeout] setting determines how long the device's Internet Services pages
will wait for a response from a connected user before terminating the connection. Enter the
required number of seconds (1 - 60) in the [Keep Alive Timeout] field.
Note: Generally, user connections will be adversely affected (slow or kept busy) if the Keep Alive
Timeout is set for a long period of time.
Physical Connection will display the current physical connection in use.
The [Maximum Connections] setting is the maximum number of simultaneous connections that
can occur at any given moment to Internet Services. Enter a number from 8 - 32 to indicate the
maximum number of clients that can be connected (for example, with open sockets) to the HTTP
server at any one time in the [Maximum Connections] field.
Note: In order for the device to operate in Secure HTTP (or HTTPS/SSL) mode, the device must
possess a correctly configured Machine Digital Certificate. For information on Machine Digital
Certificate, refer to Security Certificate Management on page 179.
e. Click on the [Apply] button to accept the changes.
Configure Network Connectivity Protocols with Internet Services
Internet Services is a series of web pages, hosted on the embedded HTTP server of the device, allowing
configuration of services and settings using a web browser.
Refer to Network Installation on page 69, of this guide and follow the instructions to configure
protocols.
To configure individual protocols only, using your web browser, from the Properties tab perform the
following steps:
Note: To configure this feature or these settings access the Properties tab as a System
Administrator. For details, refer to Access Internet Services as System Administrator on page 24.
1. From the Properties tab, click on the [Connectivity] link.
To Next Page
Loading...
Need help?
General
