Administrator’s Guide for SIP-T58V/T58A/T56A/CP960 IP Phones
238
Parameter features.dnd_refuse_code <y0000000000xx>.cfg
Description
It configures a return code and reason of SIP response messages when rejecting an incoming call by DND.
A specific reason is displayed on the caller’s phone screen.
Permitted
Values
404-Not Found
480-Temporarily Unavailable
486-Busy Here, the caller’s phone screen will display the reason “Busy Here” when the callee enables
DND feature.
603-Decline
Default 480
Web UI Features->General Information->Return Code When DND
Parameter features.exit_dnd_mode_enable <y0000000000xx>.cfg
Description
It enables or disables the phone to display Exit DND mode. after DND is activated.
Note: It works only if “features.dnd.enable” is set to 1 (On). It is only applicable to CP960 phones.
Permitted
Values
0-Disabled
1-Enabled, users can tap Exit DND mode. from the idle screen to deactivate DND.
Default 1
DND Feature Configuration
After you choose a DND mode, you can configure DND feature for all lines or a specific line. It depends on the DND
mode (except CP960):
l Phone (default): DND feature is effective for all lines.
l Custom: DND feature can be configured for a specific line or multiple lines.
Note
DND mode is set by the parameter “features.dnd_mode”.
Yealink phones also support DND on code and off code to activate and deactivate server-side DND feature. They may
vary on different servers.
Topics
DND in Phone Mode Configuration
DND in Custom Mode Configuration
DND in Phone Mode Configuration
The following table lists the parameters you can use to configure DND in Phone mode.
Parameter features.dnd.enable <y0000000000xx>.cfg
Description
It triggers the DND feature to on or off.
Note: It works only if “features.dnd.allow” is set to 1 (Enabled) and the value of the parameter “fea-
tures.dnd_mode” is set to 0 (Phone) (except CP960 phones).
Permitted
Values
0-Off
1-On, the phone will reject incoming calls on all accounts.
To Next Page
Loading...
Need help?
General
