Yealink T5 Series Administrator's Guide

Administrator’s Guide for SIP-T58V/T58A/T56A/CP960 IP Phones
22
Default 0
Web UI Network->Basic->Internet Port->Mode(IPv4/IPv6)
Phone UI Settings->Advanced Settings (default password: admin) ->Network->WAN Port->IP Mode
[1]
If you change this parameter, the phone will reboot to make the change take effect.
IPv4 Configuration
The following table lists the parameters you can use to configure IPv4.
Parameter
static.network.internet_port.type
[1]
<y0000000000xx>.cfg
Description
It configures the Internet port type for IPv4.
Note: It works only if “static.network.ip_address_mode” is set to 0 (IPv4) or 2 (IPv4 & IPv6).
Permitted
Values
0-DHCP
1-PPPoE
2-Static IP Address
Default 0
Web UI Network->Basic->IPv4 Config->Configuration Type
Phone UI Settings->Advanced Settings (default password: admin) ->Network->WAN Port->IPv4->Type
Parameter
static.network.internet_port.ip
[1]
<y0000000000xx>.cfg
Description
It configures the IPv4 address.
Example:
static.network.internet_port.ip = 192.168.1.20
Note: It works only if “static.network.ip_address_mode” is set to 0 (IPv4) or 2 (IPv4 & IPv6), and "stat-
ic.network.internet_port.type" is set to 2 (Static IP Address).
Permitted
Values
IPv4 Address
Default Blank
Web UI Network->Basic->IPv4 Config->Configuration Type (Static IP)->IP Address
Phone UI
Settings->Advanced Settings (default password: admin) ->Network->WAN Port->IPv4->Type (Static IP) -
>IP Address
Parameter
static.network.internet_port.mask
[1]
<y0000000000xx>.cfg
Description
It configures the IPv4 subnet mask.
Example:
static.network.internet_port.mask = 255.255.255.0
Note: It works only if “static.network.ip_address_mode” is set to 0 (IPv4) or 2 (IPv4 & IPv6), and "stat-
ic.network.internet_port.type" is set to 2 (Static IP Address).
Permitted
Values
Subnet Mask
Default Blank

Yealink T5 Series Specifications

General

Brand	Yealink
Model	T5 Series
Category	IP Phone
Language	English