EasyManuals Logo
Home>Yealink>IP Phone>T5 Series

Yealink T5 Series Administrator's Guide

Yealink T5 Series
472 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #380 background imageLoading...
Page #380 background image
Administrators Guide for SIP-T58V/T58A/T56A/CP960 IP Phones
374
Variable Value Phone Action
CallWaitingOff Deactivate the call waiting feature.
AlwaysFwdOn/BusyFwdOn/NoAnswFwdOn=xxx=n
Activate an always/busy/no answer forward feature to xxx for the
IP phone (xxx means the destination number)
The valid value of “n means the duration time (seconds) before
forwarding incoming calls (n is the times of 6, for example, 24). It
is only applicable to no answer forward feature.
Note: For Yealink phones, it works only if features.fwd.allow is
set to 1 (Enabled) and call forward mode is Phone, the
always/busy/no answer forward feature will apply to all the
accounts on the phone.
Example:
http://10.10.20.10/servlet?key=NoAnswFwdOn=1001=24
AlwaysFwdOff/BusyFwdOff/NoAnswFwdOff
Deactivate the always/busy/no answer forward feature for the IP
phone.
Note: For Yealink phones, it works only if features.fwd.allow is
set to 1 (Enabled) and call forward mode is Phone, the
always/busy/no answer forward feature will apply to all the
accounts on the phone.
Example:
http://10.10.20.10/servlet?key=NoAnswFwdOff
CALLEND/CallEnd End a call.
ASW/CANCEL/HOLD/UNHOLD:xxx
Answer/end/hold/unhold a call (xxx refers to the call-id of the
active call).
Example:
http://10.10.20.10/servlet?key=ASW:33093
Note: To get the call-id of the active call, configure the action
URL: http(s)://<phoneIPAddress>/help.xml?CallId=$call_id. For
more information, refer to Action URL.
Action URI Configuration
The following table lists the parameters you can use to configure action URI.
Parameter features.action_uri.enable <y0000000000xx>.cfg
Description It enables or disables the phone to receive the action URI requests.
Permitted
Values
0-Disabled
1-Enabled
Default 1
Parameter features.show_action_uri_option <y0000000000xx>.cfg
Description
It enables or disables the phone to pop up the Allow Remote Control prompt.
Note: It works only if features.action_uri.enable” is set to 1 (Enabled).

Table of Contents

Other manuals for Yealink T5 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink T5 Series and is the answer not in the manual?

Yealink T5 Series Specifications

General IconGeneral
BrandYealink
ModelT5 Series
CategoryIP Phone
LanguageEnglish

Related product manuals