Yealink T5 Series Administrator's Guide

Call Features
255
Parameter features.feature_key_sync.enable <y0000000000xx>.cfg
Description It enables or disables to synchronize the feature status between the IP phone and the server.
Permitted
Values
0-Disabled
1-Enabled, the phone send a SUBSCRIBE message with event “as-feature-event” to the server.
Default 0
Parameter features.forward.feature_key_sync.enable <y0000000000xx>.cfg
Description
It enables or disables the forward feature synchronization.
Note: It works only if “features.feature_key_sync.enable” is set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled, server-based call forward is enabled. Server and local phone call forward are synchronized.
Default 1
Parameter
features.forward.feature_key_sync.local_pro-
cessing.enable
<y0000000000xx>.cfg
Description
It enables or disables the local forward when call forward feature synchronization is enabled.
Note: It works only if “features.feature_key_sync.enable” and “features.forward.feature_key_sync.enable”
are set to 1 (Enabled). The value configured by the parameter “account.X.features.forward.feature_key_
sync.local_processing.enable” takes precedence over that configured by this parameter.
Permitted
Values
0-Disabled, call forward is performed on the server side only.
1-Enabled, call forward is performed on both server side and locally.
Default 0
Parameter
account.X.features.forward.feature_key_sync.local_
processing.enable
[1]
<MAC>.cfg
Description
It enables or disables the local forward when call forward feature synchronization is enabled.
Note: It works only if “features.feature_key_sync.enable” and “features.forward.feature_key_sync.enable”
are set to 1 (Enabled).
Permitted
Values
0-Disabled, call forward is performed on the server side only.
1-Enabled, call forward is performed on both server side and locally.
Default Blank
[1]
X is the account ID. For T58V/T58A/T56A, X=1-16; for CP960, X=1.
Call Transfer
Call transfer enables the phones to transfer an existing call to a third party. For example, if party A is in an active call
with party B, party A can transfer this call to party C (the third party). Then, party B will begin a new call with party C,
and party A will disconnect.
Yealink phones support call transfer using the REFER method specified in RFC 3515 and offer three types of transfer:
l Blind Transfer -- Transfer a call directly to another party without consulting. Blind transfer is implemented by a
simple REFER method without Replaces in the Refer-To header.

Yealink T5 Series Specifications

General

Brand	Yealink
Model	T5 Series
Category	IP Phone
Language	English