Using Handsets with T58V/T58A/T56A Phones
383
Using Handsets with T58V/T58A/T56A Phones
You can turn Yealink T58V/T58A/T56A phone to the corded-cordless phone. The corded-cordless phone consists of a
T58V/T58A/T56A phone, a DECT USB dongle DD10K and a handset. The supported handsets include W52H, W56H,
W53H and DD phone. The T58V/T58A/T56A phone acts as a base station and Handset 1. Users can register up to other
four handsets to one phone. It allows users to manage calls when they are away from their desk.
To use this feature, you should insert a DD10K into the rear USB port on the phone in advance.
Note that you can still use the phone features as usual on the corded-cordless phone.
Note
To use this feature, you should set "static.usb.power.enable" to 1 (Enabled).
Topics
Handset Backlight
Handset Keypad Light
Handset Wallpaper
Handset Screen Saver
Handset Name
Number Assignment
End Call on Hook
Advisory Tones
Base PIN
DECT Intercom
Shared Directory
Master-Slave Mode
Repeater Settings Parameters
Handset Settings Parameters
Handset Firmware Upgrade Configuration
Handset Backlight
The handset backlight in charger or out of charger can be configured independently.
You can enable the backlight to be on for about 30 minutes when the handset is charged, and then you can check the
charging state during this period. You can also enable the backlight to be on for about 30 minutes when the handset is
not charged. The backlight will be turned off after the handset is idle for a period of time. When an incoming call
arrives, a key is pressed or the status of handset changes, the backlight is automatically turned on.
It is not applicable to DD phones.
Topic
Handset Backlight Configuration
Handset Backlight Configuration
The following table lists the parameters you can use to configure the handset backlight.
Parameter custom.handset.backlight_in_charger.enable <y0000000000xx>.cfg
Description It enables or disables the handset backlight to be on for about 30 minutes when it is in the charging state.