Administrator’s Guide for SIP-T58V/T58A/T56A/CP960 IP Phones
62
If it is set to “any”, you can use IP address or any domain name to access the web user interface of the
phone.
Default any
Web Server Type Configuration
Yealink phones support both HTTP and HTTPS protocols for accessing the web user interface. You can configure the
web server type. Web server type determines access protocol of the web user interface. If you disable to access web
user interface using the HTTP/HTTPS protocol, both you and the user cannot access the web user interface.
The following table lists the parameters you can use to configure web server type.
Parameter
static.wui.http_enable
[1]
<y0000000000xx>.cfg
Description It enables or disables to access the web user interface of the phone over a non-secure tunnel (HTTP).
Permitted
Values
0-Disabled
1-Enabled
Default 1
Web UI Network->Advanced->Web Server->HTTP
Phone UI Settings->Advanced Settings (default password: admin) ->Network->Web Server->HTTPS Status
Parameter
static.network.port.http
[1]
<y0000000000xx>.cfg
Description
It configures the port used to access the web user interface of the phone over a non-secure tunnel
(HTTP).
Permitted
Values
Integer from 1 to 65535
Default 80
Web UI Network->Advanced->Web Server->HTTP Port (1~65535)
Phone UI Settings->Advanced Settings (default password: admin) ->Network->Web Server->HTTP Port
Parameter
static.wui.https_enable
[1]
<y0000000000xx>.cfg
Description It enables or disables to access the web user interface of the phone over a secure tunnel (HTTPS).
Permitted
Values
0-Disabled
1-Enabled
Default 1
Web UI Network->Advanced->Web Server->HTTPS
Phone UI Settings->Advanced Settings (default password: admin) ->Network->Web Server->HTTPS Status
Parameter
static.network.port.https
[1]
<y0000000000xx>.cfg
Description It configures the port used to access the web user interface of the phone over a secure tunnel (HTTPS).
Permitted
Values
Integer from 1 to 65535
Default 443
Web UI Network->Advanced->Web Server->HTTPS Port (1~65535)