13185L-002 Rev. A 1/24/06 110XiIIIPlus Maintenance Manual Page 4-5
Maintenance Section 4
Safety Information
Equipment Safety Tips
After reviewing each procedure, place a check in the box.
îš… The AC power plug and IEC 320 connectors on all
Zebra printers must bear the certification mark of at least one of the
international safety organizations listed below.
îš… Unless indicated otherwise, turn the power Off (O) before performing
any maintenance procedures on the printer. Disconnect the AC power
cord from the power source.
îš… Zebra printers comply with international regulations governing radiated
emissions when using fully shielded data cables. Data cables must be
fully shielded and fitted with metal or metallized connector shells.
Required shielded data cables and connectors prevent radiation and
reception of electrical noise. Use of unshielded data cables may
increase radiated emissions above the regulated limits.
îš… Permanent damage to the Flash memory will result if you turn on the
printer with Flash memory chips installed in the wrong direction.
To Next Page
Loading...
Need help?
General
