Zebra 110XiIII Plus Series User Manual

13185L-002 Rev. A 1/24/06 110XiIIIPlus Maintenance Manual Page 2-39
Operations Overview Section 2
For any errors, check that your communication parameters are correct. Set the print width
equal to or less than the label width used for the test.
Press NEXT/SAVE to display CONTROL PREFIX.
Control Prefix Character
The control prefix character is a two-digit hex value. Once configured, this character
signifies the start of a ZPL/ZPL II control instruction.
Press the left oval key to move to the next digit position, and press the right oval key to
increase the value of the digit. (The displayed H is not entered as part of the value.)
Press NEXT/SAVE to display FORMAT PREFIX.
Format Prefix Character
The format prefix character is a two-digit hex value. Once configured, this character
signifies the start of a ZPL or ZPL II format instruction.
Press the left oval key to move to the next digit position, and press the right oval key to
increase the value of the digit. (The displayed H is not entered as part of the value.)
Press NEXT/SAVE to display DELIMITER CHAR.
Note • On diagnostic printouts:
FE indicates a framing error.
OE indicates an overrun error.
PE indicates parity error.
NE indicates noise.
Default: 7E (tilde)
Range:
00–FF (Exclude the values indicated on the ASCII Code Chart in the
ZPL II Guide Volume II, Appendix B.)
Default: 5E (caret)
Range:
00–FF (Exclude the values indicated on the ASCII Code Chart in the
ZPL II Guide Volume II, Appendix B.)
CONTROL PREFIX
< > EH +7
FORMAT PREFIX
<^> EH +5

Zebra 110XiIII Plus Series Specifications

General

Brand	Zebra
Model	110XiIII Plus Series
Category	Printer
Language	English