Page 4-90 110XiIIIPlus Maintenance Manual 13185L-002 Rev. A 1/24/06
Section 4 Maintenance
Install the Rewind Option
1. Refer to Figure 4-60. Place a flat washer (2) onto one of the screws (8). Use the
Allen wrench provided in the kit to place this mounting screw through the lower
access hole in the side plate and through the idler pulley mounting slot in the printer
main frame. On the electronics side of the printer main frame, attach the idler shaft
(22) to the mounting screw.
2. Position the idler shaft in the middle of the mounting slot and tighten the mounting
screw. Apply a very small amount of grease (provided in kit) to the idler shaft with a
toothpick or small screwdriver. Keep excess grease away from other components.
3. Slide the idler pulley (20), flat side out, onto the idler shaft.
4. In the lower center portion of the main frame, remove the cover plate from the
rewind spindle mounting hole.
5. Slide the bearing housing assembly (11) out of the media rewind spindle
assembly (5).
6. Install the bearing housing assembly on the printer main frame using three screws
(1) and three flat washers (2). Do not tighten the screws at this time.
7. Insert the shaft of the rewind spindle (5) through the bearing housing assembly.
8. Place the wave washer (16), flat washer (15), and pulley, recessed side facing away
from the main frame, (12) onto the rewind spindle shaft.
9. Slide the spacer (23) on the rewind spindle shaft. Press the E-ring (13) into the
groove in the rewind spindle shaft.
10. Attach the platen support bracket (7) to the side plate with two flat washers (2) and
two screws (8). Do not tighten the screws at this time.
11. Remove the plastic plug from the rewind platen mounting hole near the bottom of
the main frame.
12. Insert the long end of the rewind platen shaft (4) through the rewind platen
mounting hole.
13. Place the flange bearing (3) over the left end of the rewind platen shaft. Press the
bearing into the mounting hole with the flange on the outside (left side) of the main
frame.
14. Place the opposite end of the rewind platen shaft through the platen support
bracket (7).
15. Place the remaining flange bearing (3) over the right end of the rewind platen shaft
with the flange of the bearing on the outside (right side) of the platen support
bracket. Press it into the mounting hole in the platen support bracket and secure with
the E-ring (9).
16. Use the Allen wrench to tighten the mounting screws that secure the platen support
bracket to the side plate. The bracket may need adjustment later.
17. Slide the spacer (21) onto the rewind platen shaft.
18. Slide the rewind platen pulley (17) onto the rewind platen shaft and align the two
pulley set screws with the flat surfaces of the rewind platen shaft.
To Next Page
Loading...
Need help?
General
