Zebra 110XiIII Plus Series User Manual

13185L-002 Rev. A 1/24/06 110XiIIIPlus Maintenance Manual Page 2-47
Operations Overview Section 2
Set LCD Adjust
This parameter adjusts the brightness of your display.
Press the right oval key to increase the value (increases the brightness). Press the left oval
key to decrease the brightness.
Press NEXT/SAVE to display FORMAT CONVERT.
Set Format Convert
This parameter selects the bitmap scaling factor. The first number is the original dpi
(dots per inch) value for which the ZPL format was written; the second number is the dpi
to which you wish to scale (usually the dpi of the printer being used).
Press the right or left oval key to display other choices.
Press NEXT/SAVE to display IDLE DISPLAY.
Idle Display
This parameter selects the LCD options for the real-time clock.
Press the right or left black oval key to display other choices.
Press NEXT/SAVE to display RTC DATE.
Default: 10
Range: 00 to 19
Default: None
Selections: None, 150 → 300, 150 → 600, 200 → 600, 300 → 600
LCD ADJUST +13
-+
FORMAT CONVERT
NONE
Note • If the default value is not selected, pressing either black oval key briefly
displays the firmware version of the printer.
Default: Firmware version
Selections:
mm/dd/yy (24 hour), mm/dd/yy (12 hour), dd/mm/yy (24 hour),
dd/mm/yy (12 hour)
IDLE DISPLAY
FW VERSION

Zebra 110XiIII Plus Series Specifications

General

Brand	Zebra
Model	110XiIII Plus Series
Category	Printer
Language	English