Page 4-132 110XiIIIPlus Maintenance Manual 13185L-002 Rev. A 1/24/06
Section 4 Maintenance
6. From the front of the printer, remove the two antenna carrier assembly mounting
screws.
7. Remove the antenna carrier assembly from the front of the printer.
Install the New Antenna Carrier Assembly
1. Refer to Figure 4-91.
Install the new antenna carrier assembly by sliding the back of
the assembly in first, then secure it using the mounting screws previously removed.
2. Connect the cable to the antenna carrier assembly.
3. Reinstall the mounting screws that secure the printhead support access panel to the
printhead support.
4. Refer to RRP No. 2 on page 4-16 and reinstall the electronics cover.
5. Open the media door and reinstall media and ribbon.
6. Reconnect the data cables and AC power cord.
7. Turn the printer On (l).
RFID Power PC Board Assembly
Remove the RFID Power PC Board Assembly
1. Refer to RRP No. 1 on page 4-14. Turn the printer Off (O) and remove the power
cord. Disconnect the printer communications cable.
2. Refer to RRP No. 2 on page 4-16 and remove the electronics cover
Note • RFID kits are available for Zebra Authorized Service Providers only.
Caution:
The printer electronics are susceptible to static discharge. Before proceeding, it
is highly recommended that the technician wear an antistatic wrist strap
connected to the printer chassis.
To Next Page
Loading...
Need help?
General
