Page 2-14 110XiIIIPlus Maintenance Manual 13185L-002 Rev. A 1/24/06
Section 2 Operations Overview
Remove Liner
Because the capacity of the rewind spindle is a standard-size media roll, Zebra
recommends performing this procedure whenever you change the media.
1. Unwind approximately 36 in. (900 mm) of liner from the rewind spindle. Cut it off
at the spindle.
2. Pull out the hook. Slide the liner off the rewind spindle and discard.
Load Fanfold Media
Refer to Figure 2-10.
Fanfold media feeds through either the bottom or rear access slot from outside the printer.
1. Open the printhead.
2. Slide the media guide as far away from the printer frame as possible.
3. Load media as shown. If in Cutter Mode, route media through the cutter.
4. Slide in the media guide so it just touches, but does not restrict, the edge of the roll.
5. Close the printhead.
Note • You do not need to turn the printer Off (O) for this procedure.
To Next Page
Loading...
Need help?
General
