Page 2-40 110XiIIIPlus Maintenance Manual 13185L-002 Rev. A 1/24/06
Section 2 Operations Overview
Delimiter Character
The delimiter character is a two-digit hex value. Once configured, this character acts as a
parameter place marker in ZPL/ZPL II. Refer to the ZPL II Programming Guide for more
information.
Press the left oval key to move to the next digit position, and press the right oval key to
increase the value of the digit. (The displayed H is not entered as part of the value.)
Press NEXT/SAVE to display MODE.
Select ZPL Mode
The printer accepts label formats written in either ZPL or ZPL II. Refer to the
ZPL II Programming Guide for more information on the differences between ZPL and
ZPL II.
The printer remains in the selected mode until changed by this front panel instruction or by
sending the ^SZ ZPL/ZPL II command to the printer.
Press the right or left oval key to display other selections.
Press NEXT/SAVE to display MEDIA POWER UP.
Power Up and Head Close Parameters
Media Power Up
Turning the printer On (l) determines the action of the media. Calibration recalibrates the
media and ribbon sensors, Feed feeds the label to the first web, Length calculates the
length of the label, and No Motion means the media does not move.
Press the right or left oval key to display other selections.
Press NEXT/SAVE to display HEAD CLOSE.
Default: 2C (comma)
Range: 00–FF (Exclude the values indicated on the ASCII Code Chart.)
Default: ZPL II
Selections: ZPL II, ZPL
DELIMITER CHAR
<,> CH +2
ZPL MODE
ZPL II
Default: Calibration
Selections: Feed, Calibration, Length, No Motion
MEDIA POWER UP
CALIBRATION
To Next Page
Loading...
Need help?
General
