13185L-002 Rev. A 1/24/06 110XiIIIPlus Maintenance Manual Page 2-33
Operations Overview Section 2
3. The display shows INITIALIZE CARD. Press the right oval key to select YES. The
display prompts ARE YOU SURE.
4. Press the right oval key to select YES to begin the initialization, or press the left
oval key to select
NO to cancel the request and return to the INITIALIZE CARD
prompt.
Press SETUP/EXIT followed by NEXT/SAVE once you have selected YES.
If initialization is still in process, the display flashes between CHECKING B: and
PRINTER IDLE.
When initialization is complete, the printer automatically exits Configuration Mode and
the display shows PRINTER READY.
Initialize Flash Memory
This selection initializes the Flash memory.
1. Press the right oval key to select
YES. If your printer is set to require a password,
you are prompted to enter it. Enter the password using the left oval and right oval
keys and then press NEXT/SAVE.
2. The display shows INITIALIZE FLASH MEM. Press the right oval key to select
YES. The display prompts ARE YOU SURE.
3. Press the right oval YES to begin initialization, or press the left oval key to select
NO to cancel the request and return to INITIALIZE FLASH.
4. Press SETUP/EXIT followed by NEXT/SAVE. If initialization is still in process,
the display flashes between CHECKING E: MEMORY and PRINTER IDLE.
5. When initialization is complete, the printer automatically exits the Configuration
Mode and displays PRINTER READY.
ARE YOU SURE
NO YES
Note • Depending on the amount of memory in the memory card, initialization
may take up to five minutes to complete.
Note • Perform this operation only when it is necessary to erase all previously
stored information in the Flash memory. If you do not want to erase all stored
information, press NEXT/SAVE to bypass the operation.
INIT FLASH MEM.
YES
ARE YOU SURE
NO YES
Note • Depending on the amount of free Flash Memory, initialization may take
up to one minute to complete.
To Next Page
Loading...
Need help?
General
