Zebra 110XiIII Plus Series User Manual

Page 4-96 110XiIIIPlus Maintenance Manual 13185L-002 Rev. A 1/24/06
Section 4 Maintenance
Interface Boards
Internal PrintServer II
Hardware Description
Figure 4-65. Internal PrintServer II
Test Button: This generates a detailed PrintServer II configuration label.
Status Indicator: A bicolored indicator displays the state of the PrintServer II.
Ethernet Connection: Connection for a 10Base-T cable. Connecting the PrintServer II
does not interrupt network operation.
Ribbon Connector: The internal PrintServer II is powered by the printer; no additional
power source is required.
Ribbon Cable
Connector
Test
Button
Status
Indicator
Ethernet
Connector
Note • To print a PrintServer II configuration label from your Zebra printer, a 4
in. wide by 6 in. long (100 mm wide by 150 mm long) label is recommended. If
the label is smaller, some information may print outside the label edges. Some
of the heading information on the right side of the label will not print. Refer to
Figure 4-66 for any missing data.

Zebra 110XiIII Plus Series Specifications

General

Brand	Zebra
Model	110XiIII Plus Series
Category	Printer
Language	English