13185L-002 Rev. A 1/24/06 110XiIIIPlus Maintenance Manual Page 4-67
Maintenance Section 4
Replace the Ribbon Take-Up Pulley
1. Refer to RRP No. 1 on page 4-14. Turn the printer Off (O) and remove the AC
power cord and data cables.
2. Refer to RRP No. 2 on page 4-16 and remove the electronics cover.
3. Refer to RRP No. 6 on page 4-25 and remove the main drive belt.
4. Refer to Figure 4-41. Remove the E-ring securing the pulley.
Figure 4-41. Replace the Ribbon Take-up Pulley
5. Slide the ribbon take-up pulley off the shaft.
Caution:
Unless indicated otherwise, turn the printer Off (O) and disconnect the printer
from the power source before performing the following maintenance.
Caution:
This installation must be performed by a qualified service technician.
Caution:
Wear protective eyewear when removing E-rings, C-clips, snap rings, and
springs. All of these are under tension and could fly off while being removed.
Ribbon Take-Up
Pulley
E-Ring
Spacer
Flat Washer
Wave Washer
To Next Page
Loading...
Need help?
General
