Page 4-22 110XiIIIPlus Maintenance Manual 13185L-002 Rev. A 1/24/06
Section 4 Maintenance
Install the Main Logic Board
1. Refer to Figure 4-12. Reinstall the two standoffs into the main logic board.
2. Install the main logic board using the screw and nut previously removed.
3. Refer to Figure 4-11. Reinstall the screws and studs for the serial and parallel
interface connectors.
4. Reinstall the PCMCIA board by pushing it onto the two standoffs and into
connectors P23 and P24, securing it with the previously removed screw.
5. Refer to Figure 4-4. Reconnect all ribbon and small wire connections to the main
logic board.
6. Reinstall the memory or font card into the PCMCIA board and reinstall the shield.
7. Reinstall any other option boards previously removed.
8. Reinstall the electronics cover.
9. Reinstall the AC power cord and restore power.
10. Turn the printer On (l) and verify operation.
11. Turn the printer Off (O).
12. Press and hold the Left Black Oval while turning the printer On (l), hold the Left
Black Oval until all front panel lights come on.
13. Press NEXT/SAVE until MODEL SELECT appears.
14. Press the Left Black Oval or the Right Black Oval until you model appears.
To Next Page
Loading...
Need help?
General
