Zebra 110XiIII Plus Series User Manual

Page 4-14 110XiIIIPlus Maintenance Manual 13185L-002 Rev. A 1/24/06
Section 4 Maintenance
Routine Referral Procedures (RRP)
Routine Referral Procedures are commonly used steps that are performed often during
corrective maintenance. These procedures are referenced throughout this section of the
manual.
RRP No. 1: Prepare Printer for Maintenance
Remove Power and Disconnect Printer
Refer to Figure 4-5.
1. Turn the printer Off (O).
2. Remove the AC power cord.
Refer to Figure 4-6.
3. Parallel Data Cable: Remove wire retainers from the parallel data cable connector.
Pull the data cable connector away from the parallel data port connector.
4. Serial Data Cable: Loosen the screws securing serial data cable connector and pull
it away from the serial data port connector.
5. USB Data Cable: Pull the USB connector away from the USB connector.
Figure 4-5. Power Cord Removal and Installation
Caution:
Unless indicated otherwise, turn the printer Off (O) and disconnect the printer
from the power source before performing the following maintenance.
AC Power
Switch
l =On
O =Off
AC Power
Cord Connection
AC Power Cord
Power Socket

Zebra 110XiIII Plus Series Specifications

General

Brand	Zebra
Model	110XiIII Plus Series
Category	Printer
Language	English