13185L-002 Rev. A 1/24/06 110XiIIIPlus Maintenance Manual Page 4-129
Maintenance Section 4
2. Two screws, spacers, and nuts:
a. You must remove the MLB and PCMCIA/wireless boards from the printer together,
and then separate them.
b. Remove the screw securing the PCMCIA/wireless board to a metal standoff on the
printer chassis.
Figure 4-89. Standoffs
Install the Wireless PCMCIA or PCMCIA Option Board Assemblies
1. Refer to Figure 4-90. Align the two connectors on the wireless PCMCIA or
PCMCIA Option board assemblies with P23 and P24 on the MLB and then push
them together.
Standoff to
Main Frame
MLB
Standoff to
Main Frame
MLB
PCMCIA
PCMCIA
Mounting
Screw
Plastic
Standoffs
Nuts
Spacers
Screws
Mounting
Screw
To Next Page
Loading...
Need help?
General
