Page 2-2 110XiIIIPlus Maintenance Manual 13185L-002 Rev. A 1/24/06
Section 2 Operations Overview
Report Damage
If you discover shipping damage:
• Immediately notify the shipping company and file a damage report with them.
Zebra Technologies is not responsible for any damage incurred during shipment
of the equipment and will not repair this damage under warranty.
• Keep the carton and all packing material for inspection.
• Notify your authorized Zebra reseller.
Storage
If you are not placing the printer into operation immediately, repackage it using the
original packing materials. The printer may be stored under the following conditions:
• Temperature: –40° to 140° F (–40° to 60° C)
• Relative humidity: 5% to 85% non-condensing
Media and Ribbon Requirements
Because print quality is affected by media and ribbon, printing speeds, and printer
operating modes, it is very important to run tests for your applications.
We strongly recommend using Zebra Technologies-brand supplies for continuous high-
quality printing. A wide range of paper, polypropylene, polyester, and vinyl stock has been
specifically engineered to enhance the printing capabilities of the printer and to ensure
against premature printhead wear.
• Continuous roll media, fanfold media, or card stock with optional perforations and
registration holes may be used.
• Printhead life may be reduced by the abrasion of exposed paper fibers when using
perforated media.
• In Thermal Transfer Mode, use ribbon that is as wide as or wider than your media.
If the ribbon is narrower than the media, areas of the printhead are unprotected
and subject to premature wear. (When printing in Direct Thermal Mode, ribbon is
not used and should not be loaded in the printer.)
To Next Page
Loading...
Need help?
General
