Zebra 110XiIII Plus Series User Manual

Page 2-48 110XiIIIPlus Maintenance Manual 13185L-002 Rev. A 1/24/06
Section 2 Operations Overview
Set RTC Date
This parameter sets the date following the convention selected in IDLE DISPLAY.
Press the left black oval key to move to the next digit position; press the right black oval
key to increase the value of the digit.
Press NEXT/SAVE to display RTC TIME.
Set RTC Time
This parameter sets the time following the convention selected in IDLE DISPLAY.
Press the left black oval key to move to the next digit position; press the right black oval
key to increase the value of the digit.
For the XiIIIPlus: Press NEXT/SAVE to display LANGUAGE. Proceed to Language on
page 2-50.
For the XiIII: Press NEXT/SAVE to display IP RESOLUTION.
IP Resolution
Depending on the selection, this parameter allows either the user or the server to select the
IP address. For more information, refer to ZebraNet Networking: PrintServer II
Installation and the Users Guide for this printer.
Press the right or left oval key to display other choices.
Press NEXT/SAVE to display IP ADDRESS.
RTC DATE
0/00/00 +0
RTC TIME
7:45 +0
Note • This display does not appear unless a ZebraNet II PrintServer is
installed.
Default: Dynamic
Selections: Dynamic, Permanent
IP RESOLUTION
DYNAMIC

Zebra 110XiIII Plus Series Specifications

General

Brand	Zebra
Model	110XiIII Plus Series
Category	Printer
Language	English