Page 2-10 110XiIIIPlus Maintenance Manual 13185L-002 Rev. A 1/24/06
Section 2 Operations Overview
Peel-Off Mode
Refer to Figure 2-6.
1. Remove the rewind plate from the front of the printer. Store it on the two mounting
screws on the inside of the front panel.
2. Open the printhead.
3. Slide the media guide and media supply guide as far away from the printer frame as
possible. Flip down the media supply guide.
4. Load media as shown.
Figure 2-6. Peel-Off Mode Loading
5. When loading media, allow approximately 36 in. (900 mm) of media to extend past
the tear-off/peel-off bar. Remove all labels from this portion to create a leader.
6. Remove the hook from the rewind spindle. If you are using a core, slide it onto the
rewind spindle until it is flush against the guide plate.
7. Wind the label liner around either the 3 in. (76 mm) core or the rewind spindle, and
reinstall the hook.
8. Flip up the media supply guide. Slide in the media guide and media supply guide so
they just touch, but do not restrict, the edge of the roll.
Before closing the printhead, ensure that:
• The media is positioned against the inside guides.
• The media is taut and parallel with itself and the pathway when wound onto the
rewind spindle/core.
9. Close the printhead.
To remove the used liner, refer to Remove Liner on page 2-14.
Note • Rewind option required.
Media
Guide
Media
Media
Supply
Guide
Closed
Open
Rewind
Spindle
Hook
Printhead Lever
Rewind
Plate
Tear-off/
Peel-off
Bar
Guide
Plate
Label
Label
Liner
To Next Page
Loading...
Need help?
General
