Zebra 110XiIII Plus Series User Manual

Page 4-40 110XiIIIPlus Maintenance Manual 13185L-002 Rev. A 1/24/06
Section 4 Maintenance
Adjust the Media Tracking
Rewind Mode
Refer to Figure 4-23. If the media walks from side to side, tears, or wrinkles against the
media rewind tracking plate, it is necessary to adjust the rewind plate assembly.
Figure 4-23. Rewind Plate Assembly
1. Remove the rewind plate assembly and loosen the two adjustment nuts attaching the
hook plate to the rewind plate.
2. Refer to Figure 4-23. Move the outer end of the hook plate up to force the media
toward the rewind tracking plate or move the outer end of the hook plate down to
force the media away from the rewind tracking plate.
3. Tighten the adjustment nuts, and reinstall the rewind plate assembly and print a
number of test labels. If problems persist, readjust the hook plate.
Hook Plate
Adjustment
Nuts
Adjustment
Slot
Top Lip
Bottom Lip
Note • Moving the outer end of the hook plate up forces the media toward the
rewind tracking plate; moving this end down moves the media away from the
tracking plate. The opposite effect occurs if the same adjustments are made on
the inner end of the hook plate.

Zebra 110XiIII Plus Series Specifications

General

Brand	Zebra
Model	110XiIII Plus Series
Category	Printer
Language	English