13185L-002 Rev. A 1/24/06 110XiIIIPlus Maintenance Manual Page 4-87
Maintenance Section 4
Rewind Option
The printer must be partially disassembled to install the various parts provided in this kit.
Follow the procedures listed below.
1. RRP No. 1 on page 4-14. Turn printer power Off (O) and disconnect the AC power
cord. Remove any communication cables.
2. RRP No. 2 on page 4-16 and remove the electronics cover.
3. RRP No. 4 on page 4-19. Disconnect all wires and cables attached to the power
supply board and remove the power supply.
4. Open the media access door, and remove all media and ribbon.
5. Refer to Figure 4-60. Remove and retain the plastic plug in the lower access hole
near the bottom of the print mechanism side plate.
Caution:
Unless indicated otherwise, turn the printer Off (O) and disconnect the printer
from the power source before performing the following maintenance.
Caution:
This installation must be performed by a qualified service technician.
To Next Page
Loading...
Need help?
General
