EasyManuals Logo
Home>GE>Medical Equipment>LOGIQ P7

GE LOGIQ P7 Service Manual

GE LOGIQ P7
602 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #129 background imageLoading...
Page #129 background image
GEDRAFT LOGIQ P9/P7
D
IRECTION 5604324, REVISION 11 DRAFT (JANUARY 24, 2019) SERVICE MANUAL
Chapter 3 - Setup Instructions 3-61
NOTE: Reboot the system to activate any changes saved from this page.
IP-Address
Type the IP Address of the Ultrasound system. NOTE: IP stands for Internet Protocol. Every
device on the network has a unique IP address.
Subnet Mask
Type the subnet mask address. NOTE: The Subnet Mask is an IP address filter that eliminates
communication/messages from network devices of no interest to your system.
Default Gateway Type the default gateway address.
Network Speed
Select the network speed (Auto Detect, 10Mbps/Half/Full Duplex, or 100 Mbps/Half/Full Duplex/
1000Mbps/Auto-negotiate)
IPv6 (R3.0 or above) Select this box if your network system support and you want to use IPv6
IPv6 Address (R3.0 or above) Type IPv6 Address of the Ultrasound system
IPv6 Prefix Length (R3.0 or
above)
Type IPv6 Prefix Length
Default IPv6 Gateway (R3.0 or
above)
Type IPv6 Gateway address
Prmary DNS Server (R3.0 or
above)
Type Primary DNS Server address
Secondary DNS Server (R3.0
or above)
Type Secondary DNS Server address
Table 3-24 Wired Connection
Preset Parameter Description
IP-Address Displays currently configured IP address
Subnet Mask Displays currently configured subnet mask address
Default Gateway Displays currently configured default gateway address
MAC Address Unique network card address of the system.
Speed (Mbps) The performance of a network connection.
Connected (min The connection time with network.
Status Current network status.
IPv6 Address (R3.0 or
above)
Displays currently configured IPv6 address
IPv6 Prefix Length (R3.0 or
above)
Displays currently configured IPv6 Prefix Length
Default IPv6 Gateway (R3.0
or above)
Displays currently configured Gateway address
Primary DNS Server (R3.0
or above)
Displays currently configured Primary DNS Server address
Secondary DNS Server
(R3.0 or above)
Displays currently configured Secondary DNS Server address
Table 3-23 Wired Network Configuration
Preset Parameter Description

Table of Contents

Other manuals for GE LOGIQ P7

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE LOGIQ P7 and is the answer not in the manual?

GE LOGIQ P7 Specifications

General IconGeneral
BrandGE
ModelLOGIQ P7
CategoryMedical Equipment
LanguageEnglish

Related product manuals