Basic copy operations
2
C451 2-8
2.3 Feeding the document
The document can be fed in either of the following two ways. Be sure to po-
sition the document correctly according to the type of document being cop-
ied.
Loading the document into the ADF
0 Do not load documents that are bound together, for example, with paper
clips or staples.
0 For details on the types of documents that can be loaded into the ADF,
refer to “Original documents” on page 6-26.
0 Do not load more than 100 sheets or so many sheets that the top of the
stack is higher than the ▼ mark, otherwise a document misfeed or dam-
age to the document or machine may occur. However, a document that
exceeds 100 pages can be scanned in separate batches. For details, re-
fer to “Scanning the document in separate batches (“Separate Scan” set-
ting)” on page 2-13.
0 If the document is not loaded correctly, it may not be fed in straight or a
document misfeed or damage to the document may occur.
0 If the document is loaded in any orientation other than with the top of the
document toward the back of the machine, be sure to select the docu-
ment orientation. For details on selecting the document orientation, refer
to “Selecting the document orientation (Original Direction settings)” on
page 2-29.
Document Feed Method Features
Using the ADF By using the ADF, a multi-page document can be fed automatically,
one page at a time. This feed method can also be used to automat-
ically scan double-sided documents.
Using the original glass Place the document directly on the original glass so that it can be
scanned. This method is best with books and other documents that
cannot be fed through the ADF.
To Next Page
Loading...
Need help?
General
