Utility mode
11
C451 11-32
11.4 Specifying administrator settings
This section describes the function and main registration parameters that
can be specified after pressing the [Utility/Counter] key, then touching
[Administrator Settings].
System Settings
Power Save Settings
Output Settings
*
1
If optional separator is installed, “Tray 2” is selected as the factory default.
Parameter Description Default Setting
Low Power Mode
Settings
Specify the desired length of time (between 10
and 240 minutes) until the machine enters Power
Save mode.
15 minutes
Sleep Mode Set-
tings
Specify the desired length of time (between 15
and 240 minutes) until the machine enters Sleep
mode.
30 minutes
Power Save Key Select which low power mode is entered when the
[Power Save] key is pressed.
• Low Power:
The touch panel goes off and the machine
enters a mode where it conserves energy.
• Sleep:
Although the machine conserves more energy
in Sleep mode than in Power Save mode, the
machine must warm up when Sleep mode is
canceled, therefore taking more preparation
time than Power Save mode.
Low Power
Enter Power Save
Mode
Specify settings for faxing. For details, refer to the
User’s Guide [Fax Operations] and the User’s
Guide [Network Fax Operations].
Normal
Parameter Description Default Setting
Print/Fax Out-
put Settings
Specify settings for faxing and printing. For details, refer to the User’s Guide
[Fax Operations] and the User’s Guide [Print Operations].
Output Tray
Settings
Select the finishing tray for each type of job (copies,
printouts, faxes and reports).
Copy: Tray 1
*1
Printer: Tray 1
*1
Print Reports: Tray
2
*2
Fax: Tray 2
*2
Bin Assign-
ment
Select whether or not Tray 1 is specified as mailbin 5
and the optional output tray is specified as mailbin 6.
Not Set
Shift Output
Each Job
Select whether or not printed copies are fed out shifted
when “Offset” is selected while optional finisher or sep-
arator is installed.
• Yes: Pages are fed out shifted.
• No: Pages are fed out without being shifted.
Yes