Utility mode
11
C451 11-77
Half-Fold Position
The folding position when printing with the “Half-Fold” setting can be
adjusted for each paper size and for each paper type.
2
Note
[Half-Fold Position] appears only if optional finisher FS-608 is installed or
if finisher FS-519 is installed with the saddle stitcher attached.
If the angle of the center folding position must be adjusted, contact your
service representative.
The adjustment range differs depending on the finisher that is installed.
!
Detail
For details on the “Center Staple & Fold” setting, refer to “Binding copies
at the center (“Center Staple & Fold” setting)” on page 2-100.
0 Before making any adjustments, use the “Half-Fold” setting to print a
single sample copy. Perform the adjustment while checking the sample
that was created.
1 Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to
“Displaying the Administrator Settings screen” on page 11-56.
2 Touch [1 System Settings].
The System Settings screen appears.
3 Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4 Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
To Next Page
Loading...
Need help?
General
