Replacing toner cartridges and staple cartridges and emptying punch scrap box
8
C451 8-54
8.5 Emptying the punch scrap box
If the punch scrap box in the punch kit installed on the finisher becomes full,
the message shown below appears (if the box can be emptied by the user).
2
Note
The setting for emptying the punch scrap box should be specified by the
service representative. For details, contact the service representative.
The default setting is “Service”. If a message appears, immediately con-
tact the service representative.
Screen when a Punch setting is selected
To Next Page
Loading...
Need help?
General
