Basic copy operations
2
C451 2-88
4 Touch [OK], and then touch [OK] again.
The Basic screen appears again.
Stapling copies (Staple settings)
2
Reminder
Copies can be fed out stapled either in the corner or at two places only
when the finisher is installed.
!
Detail
If a Staple setting is selected, the “Sort” setting is automatically selected.
A Staple setting cannot be used together with offset sorting.
If a Staple setting is to be selected, select the orientation in which the
document is positioned and the orientation of the page to be stapled,
otherwise the copies may not be stapled as desired.
For details on specifying the document orientation, refer to “Selecting the
document orientation (Original Direction settings)” on page 2-29.
Copies can be fed out stapled either in the corner or at two places.
When Finisher FS-517/FS-608 is installed
!
Detail
In order for the copies to be stapled, all of the following conditions must
be met.
- The paper width must be between 182 mm and 311.1 mm.
- The paper length must be between 139 mm and 457.2 mm.
If the “Mixed Original” setting is selected, all copies must have the same
paper width.
*1
Can only be used as cover sheets.
*2
Can be used only with Finisher FS-608.
Tray Paper weight Paper size Paper capacity
Output tray 1 64 g/m
2
to 90 g/m
2
,
91 g/m
2
to 209
g/m
2*1
A3 w to A5 v,
12-1/4 × 18 w
*2
,
11 × 17 w to 5-1/2 ×
8-1/2 w/v,
8 × 13 w
*3
,
16K w/v, 8K w
20 to 50 sets (A3 w, 11 × 17 w,
A5 v, 5-1/2 × 8-1/2 v)
20 to 100 sets (others)
To Next Page
Loading...
Need help?
General
