Utility mode
11
C451 11-82
– If more adjustment is necessary, repeat steps 6 through 9.
Punch Vertical Position Adjustment
The vertical position of punched holes when printing with a Punch setting
can be adjusted for each paper size.
2
Note
[Punch Vertical Position Adjustment] appears only if optional punch kit is
installed on finisher FS-517 or FS-608.
For details on the Punch settings, refer to “Punching holes in copies
(Punch settings)” on page 2-93.
0 Before making any adjustments, use a Punch setting to print a sample
copy. Perform the adjustment while checking the sample that was
created.
1 Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to
“Displaying the Administrator Settings screen” on page 11-56.
2 Touch [1 System Settings].
The System Settings screen appears.
3 Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4 Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
5 Touch [5 Punch Vertical Position Adjustment].
To Next Page
Loading...
Need help?
General
