Managing jobs
10
C451 10-18
3 Touch [Change Setting].
The Change Setting screen appears.
4 In the Change Setting screen, change the copy settings as desired, and
then touch [OK].
?
Is there more information about the settings?
% Refer to the appropriate section.
5 In the Release Held Job screen, touch [OK] or press the [Start] key.
The stored job appears in the Current Jobs list and is printed.
?
Can a proof copy be printed?
% For details on printing a proof copy, refer to “Printing a proof copy
of a stored job” on page 10-15.
?
How is the removal of a job from the Held Jobs list stopped?
% Touch [Cancel].
Increasing printing priority
The next job to be printed after the current job being printed can be selected.
If an Administrator mode parameter was set so that the output priority of jobs
cannot be changed, [Increase Priority] does not appear and the output prior-
ity of the jobs cannot be specified.
If the job currently being printed can be interrupted, printing is interrupted
and printing of the job given priority begins. Printing of the interrupted job is
automatically restarted once printing for the job given priority is finished.
If the job currently being printed cannot be interrupted (a job has already
been interrupted or a job was already given priority), printing is interrupted
after printing for the current job is finished.
1 Display the Current Jobs list of the Print tab.
To Next Page
Loading...
Need help?
General
