Oki MC573 Advanced Manual

- 327 -
9. Operating Management/ Specifications
• Other Settings • Fax Setting
Item Factory
default
setting
Description
Default Mode Normal Sets the default screen of fax.
Redial Tries 2 time(s) Sets the number of redial attempts.
Available range: 0 to 9 times
Redial Interval 1 minute(s) Sets the time between redial attempts.
Available range: 0 to 5 minutes
Block Junk Fax Setting OFF Sets Block Junk mode Fax.
Registered List Register / Edit (NULL) Register / Edit addresses for Block Junk Fax
when [Mode2] or [Mode3] is set.
Delete Delete addresses for Block Junk Fax when
[Mode2] or [Mode3] is set.
Ring Response 1 Ring Sets the number of rings required before
receiving an incoming fax.
Dialing Pause Duration 2 second(s) Sets the dial pause time.
Available range: 0 to 10 seconds
Rx Reduc. Rate Auto Sets the reception reduction rate.
Reduc. Margin 24 mm (0.9
inch) or
100 mm (3.9
inch)
Sets the threshold level of reception
reduction.
Available range: 0 to 100 mm (0 to
3.9 inches)
ECM Mode ON Sets whether to use the error correction
mode.
PreFix (NULL) Sets the dialing prefix. You can enter up to 40
digits.
Received Time Stamp OFF Sets whether to print the time stamp on
received faxes.
Print Check Message ON Sets whether to report the error content if a
transmission error occurs.
Duplex OFF Sets simplex or duplex for printing received
fax and the binding position for duplex
printing.
Distant Station Priority Type 1 Sets the priority order of information for
Distant Station (information of the
destination).
Priority (High > Low)
[Type 1]: Destination information > Name in
speed dial > Phone number
[Type 2]: Name in speed dial > Phone
number
Item Factory
default
setting
Description
Service Bit OFF If set to OFF, some menu items are not
displayed on the screen.
Country Code International or
U.S.A
Sets the country code.
A/R Full Print ON Sets whether to print the list of the
communication results automatically after
every 50 communications.
Daily Tx/Rx Log Report Setting OFF Enables / disables to print a daily report.
Print Time 0 Hour
0 Minute
0 Second
Sets the date and time for printing the daily
report.
Tone For Echo (For Transmission) Disable Displays only if Service Bit is ON.
Tone For Echo (For Reception) Disable Displays only if Service Bit is ON.
H/Modem Rate (For Tx) 33.6 Kbps Sets the default modem reception
transmission speed while the machine is
sending a fax.
H/Modem Rate (For Rx) 33.6 Kbps Sets the default value of the modem
transmission speed while the machine is
receiving a fax.
Attenuator 10 dB, Range:
0 - 15 dB
Enter Attenuator. Displays only if Service Bit
is ON.
MF Attenuator 8 dB, Range: 0
- 15 dB
Enter MF(Tone) Attenuator. Displays only if
Service Bit is ON.
Pulse Make Ratio 40%, Range:
33, 39, 40%
Sets to make rate of DP (10 pps) during call.
Displays only if Service Bit is ON and Tone /
Pulse setting is PULSE.
Pulse Dial Type N, Range: N,
10-N, N+1
Sets the pulse type for dialing. Displays only
if Service Bit is ON and Tone / Pulse setting
is PULSE.
MF(Tone) Duration 100 mseconds,
Range: 75, 85,
100 mseconds
Enter MF(Tone) Duration. Displays only if
Service Bit is ON and Tone / Pulse setting is
TONE.
Calling Timer 60 mseconds,
Range: 1 -
255 seconds
Displays only if Service Bit is ON.
PBX Line OFF When connecting to PBX (internal
exchange), put it to [ON].

Oki MC573 Specifications

General

Brand	Oki
Model	MC573
Category	All in One Printer
Language	English