- 333 -
9. Operating Management/ Specifications
• Print Menu
• Color Menu
• System Configuration Menu
•PCL Setup
• PS Setup
• XPS Setup
•SIDM Setup
• IBM PPR Setup
• EPSON FX Setup
• Private Print Setup
Print Menu
•Print Setup
• Printer Adjust
Print Setup
Item Factory
default
setting
Description
Copies 1 Sets the number of copies. For local printing, this setting is
invalid except for demo data.
Available range: 1 to 999
Duplex OFF Turns the duplex printing function on or off.
[OFF]: simplex printing
[Long Edge Bind]: duplex printing for long-edge binding
[Short Edge Bind]: duplex printing for short-edge binding
Media Check Enable Sets whether to check an inconsistency between the page size
and the paper size in the tray.
Override A4 / Letter Yes Set the function that automatically switches paper to print from
A4 to Letter if a tray runs out of A4 paper and Letter paper is
loaded, or from Letter to A4 if a tray runs out of Letter paper.
Resolution 600dpi Sets the resolution.
Toner Save Toner Save
Level
OFF Sets the amount of toner to be saved.
This setting is enabled when copying, printing, printing
received faxes, and printing from USB Memory.
Color All [All]: Toner Save is applied to all colors including 100% black.
[Except100%Black]: Toner Save is applied to all colors other
than 100% black.
This function is only applied to the print function.
Mono-Print Mode Auto Sets the print mode for black-and-white pages.
Orientation Portrait Sets the page orientation.
Edit Size Cassette size Sets the size of the printable page area if the size is not
specified with the paper edit size command from a computer.
Trapping OFF Set trapping
Width / Length 210 mm (8.3
inch) or
216 mm (8.5
inch)
Sets the width of a custom paper size.
Available range: 64 to 216 mm (2.5 to 8.5 inches)
297 mm (11.7
inch) or
279 mm (11
inch)
Sets the length of a custom paper size.
Available range: 90 to 1,321 mm (3.5 to 52.0 inches)
Item Factory
default
setting
Description
Manual Timeout 60 seconds Sets for how many seconds the machine waits for paper to be
fed before cancelling a job when using the manual feeder.
Timeout Injob 40 seconds Sets for how many seconds the machine waits until pages are
output from when the processing of the received data stops.
Timeout Local 40 seconds Sets how long each port is left opened after a job is complete.
(The network is excluded.)
Timeout Network 90 seconds Sets how long the network port is left opened after a job is
complete.
Print Mode Without Color Toner Alarm Sets whether to print the document in black and white or stop
with alarm when a color toner empty error occurs.
Jam Recovery Enable Sets whether to print the pages again that are not printed due
to a paper jam after the jam is cleared.
Paper Black Setting 0 Adjusts finely if the black contrast becomes weak or blots or
lines become conspicuous when printing on plain paper.
If fine blots or lines appear, decrease the value. If the dark part
becomes light, increase the value.
Paper Color Setting 0 Adjusts finely if the color contrast becomes weak, or blots or
lines become conspicuous when printing on plain paper.
If fine blots or lines appear, decrease the value. If the dark part
becomes light, increase the value.
SMR Setting Black 0 Corrects variations in print results caused by temperature and
humidity conditions and differences in print density and
frequency. Change the setting if the print quality is uneven.
Yellow 0
Magenta 0
Cyan 0
Item Factory
default
setting
Description
To Next Page
Loading...
Need help?
General
