- 424 -
11. Utility Software
You can set reception protocol (POP3, SMTP, etc.) so that the machine can receive e-mail.
1
Open the Web page of this machine.
Open the Web Page of This Machine
2
Log in as the administrator.
3
Select [Admin Setup].
4
Click [Network] > [Mail Server] on the left side of the screen.
5
Set the mail server based on the information on the setting information sheet if
necessary.
6
Click [Submit].
7
Click [E-mail] > [Receive Settings] on the left side of the screen.
8
Select [POP3] or [SMTP], and then click [To STEP2].
9
Set the POP3 protocol if necessary.
10
Click [Submit].
Set the length of idle time before entering Power Save mode.
1
Open the Web page of this machine.
Open the Web Page of This Machine
2
Log in as the administrator.
3
Click [Admin Setup].
4
Click [Management] > [Power Save].
5
Select the transition time from [Power Save Time], and then click [Submit].
E-mail Setup Setting Power Save Mode (Web Page)
To Next Page
Loading...
Need help?
General
