Measurement Process
FQ2-S4 User’s Manual
21
1
Introduction
1-2 Measurement Process
This section describes the basic flow of the measurement process.
• The measurement is started by inputting a trigger signal from an external
device.
• Images are taken according to the trigger.
• The image is measured to see if it matches the configured settings.
• You can also perform calculations based on the measurement results from
inspection items.
• The overall judgement of all inspection items are output using OR logic.
• You can output detailed measurement result from the inspection items.
• Measurement data and image data can be logged in memory in the Sensor or
in an SD card.
Trigger input
Take image
Measurement
Output
Logging
To Next Page
Loading...
Need help?
General
