Adjusting Judgement Parameters during Operation
FQ2-S4 User’s Manual
231
6
Operation
6-4 Adjusting Judgement Parameters during Operation
This Sensor enables judgement parameters to be adjusted while measurements are being performed.
Downtime can be eliminated with this feature because the production line does not have to be stopped while
making adjustments.
Preparations
This function is switched OFF as a default to prevent it from inadvertently working during operation.
Turn ON the function if you want to use it.
(Setup Mode) − [Sensor settings] − [Adjustment mode in Run]
1 Press [ON].
Changing the Judgement Parameters in Run Mode
This section describes how to change the judgement parameters without stopping measurement in Run Mode.
Run Mode
1 Select the inspection item for which you want to ad-
just the judgement parameters using the and
Buttons.
2 Press [ ] – [Adjust judgement].
3 Press the parameters and change the values of the
judgment conditions for them with the slider.
4 Press [OK].
The judgement results with the changed judgement
parameters will appear.
The changed judgement parameters will not be reflected in the measurement result until [OK] is pressed.
Important
To Next Page
Loading...
Need help?
General
