6.9.2 Displaying communication settings
Proceed as follows to display the communication settings:
Select "Diagnostics" and "Communication" in the navigation.
The web server shows a window with the following contents:
● IP address of the converter
● Name of the station
● Information as to whether the connection between the controller and the converter is active
● The standard telegram
– Table with process data for the transfer direction "controller > converter"
– Table with process data for the transfer direction "converter > controller"
Figure 6-32 Communication settings
The values are displayed in hexadecimal format in the default setting. You can switch the
display of individual values between binary and hex format by clicking on the button to the right
of the value.
Commissioning and diagnostics in the Web server
6.9 Diagnostics in the Web server
SINAMICS S210 servo drive system
152 Operating Instructions, 12/2017, A5E41702836B AA
To Next Page
Loading...
Need help?
General
