Procedure
1. First open an HTTPS Web server connection to your drive in the browser.
2. The firmware then creates a new server certificate and a private server key from the root
certificate and the private key, if they are not already available. This certificate is
individualized for the IP address of the interface used for the communication.
3. Following this, a warning is issued on the standard browser that the certificate is unknown.
4. Import the server certificate into your standard browser or deactivate the security warnings
for the SINAMICS Websites.
The exact procedure for the import can be found in the online help of the used browser.
Deactivating warnings in the most important browsers
You can deactivate warnings in the most important browser as follows:
Opera
Figure A-1 Opera1
Click "Still continue" in order to be able to communicate via a secure HTTPS connection.
Appendix
A.5 Certificates for the secure data transfer
SINAMICS S210 servo drive system
Operating Instructions, 12/2017, A5E41702836B AA 751
To Next Page
Loading...
Need help?
General
