Commissioning Manual
144 01/2017
nchronization finishes successfully, the following dialog box displays on the
tkey to exit the dialog box.
Checking the status LEDs on the SINAMICS V70 drives
When the data synchronization is completed, the LEDs on the drive indicate the drive is in ready state (
: green;
:
slow flashing green every two seconds). The drive BOP displays S-off or a fault depending on the type of connected
encoder.
The control system provides a concept of protection levels for enabling data areas. Different protection levels control
different access rights.
The control system delivered from Siemens is set by default to the lowest protection level 7 (without password). If the
password is no longer known, you must reinitialize the control system with the default machine/drive data. All passwords are
then reset to default passwords for this software release.
the control system with default machine/drive data, make sure that you have backed up your machine/drive
data; otherwise, all data are lost after rebooting with default machine/drive data.
Manufacturer password
(Default password:
Machine manufacturers
• Entering or changing part of the machine data
and drive data
• Conducting NC and drive commissioning
End-user password
(Default password:
"CUSTOMER")
End users
• Entering or changing part of the machine data
• Editing programs
• Setting offset values
•
* Protection level 7 is set automatically if no password is set and no protection level interface s
ignal is set. The protection
level 7 can be set from the PLC user program by setting the bits in the user interface.
To Next Page
Loading...
Need help?
General
