Siemens SINUMERIK 808D Commissioning Manual

Commissioning Manual
250 01/2017
3.
Press this softkey to open the dialog for loading the series archive.
4.
Enter the backup directory and select the desired archive file.
5.
Press this softkey to confirm your selection, and the archive information displays on the
screen.
6.
Check the archive information and press this softkey to start loa
ding the series commission-
ing archive.
Note
Successful loading of the data archive can delete the password. You must set the password again before proceeding. For
more information about setting a password, refer to Section "
Setting the password (Page 144)".
9.2
Setting software limit switch data
Refer to Section "Setting software limit switch data (Page 240)".
9.3
Setting backlash compensation data
Refer to Section "Setting backlash compensation data (Page 241)".
9.4
Setting leadscrew error compensation data
Refer to Section "Setting leadscrew error compensation data (Page 242)".
9.5
Tuning drive performance (PPU161.3 and PPU160.2 only)
Refer to Section "Tuning drive performance (PPU161.3 and PPU160.2 only) (Page 243)".
9.6
Creating startup archives
Refer to Section "Creating prototype machine commissioning archives (Page 246)".

Siemens SINUMERIK 808D Specifications

General

Brand	Siemens
Model	SINUMERIK 808D
Category	Control Unit
Language	English